Highlights

• FUNNYPLAYING TFT Screen - 240x160
• Helder’s GBA MegaBat1400 + LiPo Charging Module v1.2
• FUNNYPLAYING Speaker

Components

Helder LiPo Charging Module + 1400mAh LiPo Battery

This battery DOES support charge and play and is best used with a modded GBA which would include a Backlit Screen.

Custom made battery for the Game Boy Advance with a true and tested capacity. Now Easier to install and larger capacity. Checkout the Extended Tip USB-C Cable available on my site for a compatible cable for charging the battery.

• 1400Mah Capacity tested to be true capacity
• USB-C Charge Port that works with all USB-C chargers capable of 5V output
• Charge rate is at approximately 700Mah leading to about 2 hours to fully charge battery using 1A charger

• Side Facing Charge Status LED , points towards the bottom of the console
• 2 Large filter capacitors on the output to feed Cleaner Power into the GBA than standard Lipo Battery Mods
• Has proper voltage output so when the battery is Low the GBA Low Battery Light will turn on giving you approximately 5 minutes before turning off.
• JST type connector for easy battery replacement
• USB-C socket placed where it does not obstruct the Battery Cover, you do not need to cut the Hole for USB-C but it’s recommended
• Solder Points for adding an optional Wireless Charging Module

FUNNYPLAYING TFT Screen

FUNNNYPLAYING For Gameboy GBA Advance ITA NEW AGB RETRO PIXEL TFT BACKLIGHT KIT Memory Brightness Adjust The Display

• Use the lower screen of DSI to transfer, 240*160 display, the display size is the same as the original panel
• At the lowest brightness, the kit power consumption is 0.15w
• It has the same display effect as AGS-101, without ghosting, better colors and brighter backlight.
• It has a memory brightness function and can adjust the partial display window.
• Add touch to adjust brightness
• Perfect support for NES game display

FP AGS TFT Screen Kit

PRODUCTS INCLUDE:

TFT LCD                                        × 1

Main ribbon × 1

32pin ribbon                                × 1

40pin ribbon                                × 1

Welding line                                × 3

3M glue                                       × 1

NOTES

• Modification requires cutting the shell but not the window
• If you adjust the display window, you need to weld the select L R key
• Good viewing angle, but not better than IPS
• The original lens can be used, the lens is not included in the kit.
• The IPS lens window is too large and not perfect. It is not recommended to use it together.

Screen capture of FUNNYPLAYING listing on AliExpress